Canon ImageRunner 600 Service Manual page 433

10. Removing the Drum Drive
Assembly
Construction
1) Remove the rear cover.
2) Remove the high-voltage transformer
(DC).
3) Open the system box assembly. (See Fig-
ure 4-D401.)
4) Remove the high-voltage transformer
(AC). (See Figure 9-H701.)
5) Remove the two screws [1], and detach
the flywheel [2].
6) Loosen the two screws [3], and remove
the binding screw [4] (w/ a spring); then,
detach the gear [5] of the drum shaft.
Caution:
When removing the screw from the
drum shaft gear, pay attention to the di-
rection of rotation of the gear. (Be sure
to turn it counterclockwise.)
COPYRIGHT © 1999 CANON INC.
CHAPTER 9 EXTERNALS/AUXILIARY MECHANISMS
CANON imageRUNNER 600 REV.1 JAN. 2000 PRINTED IN U.S.A.
[1]
Figure 9-D712
[3]
[3]
Figure 9-D713
[2]
[4]
[5]
9-57