CHAPTER 13 TROUBLESHOOTING
8) Connect the power plug to the power outlet, and turn on the main power switch and the control
panel power soft switch.
9) Select COPIER>FUNCTION>LASER in service mode.
10) Select POWER-A, and press the OK key.
11) Check to see if the reading of the digital multimeter is between 6 and 8 mV so that the power of
the laser A is at a correct level.
12) Select POWER-B, and press the OK key.
13) Check to see if the reading of the digital multimeter is between 6 and 8 mV so that the power of
the laser B is at a correct level.
13-40
COPYRIGHT © 1999 CANON INC.
CANON imageRUNNER 600 REV.1 JAN. 2000 PRINTED IN U.S.A.