Installing To The Copier - Canon ImageRunner 600 Service Manual

B.

Installing to the Copier

Keep the following in mind for the instal-
lation:
1. Observe all applicable regulations of the
country.
2. Check to make sure that the host copier
has been properly installed.
3. Disconnect the copier's power plug before
starting the work.
4. Identify the screws by type (length, diam-
eter) and location.
5. Prepare the computer at the service station
with the necessary settings.
1) Remove the four screws [2], and detach
the face plate [1] of the copier's rear cover.
2) If the Card Reader-A1 is to be installed,
connect the card reader relay cable (9P) to
J4 of the controller.
COPYRIGHT © 1999 CANON INC.
[2]
CANON imageRUNNER 600 REV.1 JAN. 2000 PRINTED IN U.S.A.
CHAPTER 11 INSTALLATION
[1]
Figure 11-B601
J4
Cable for the card reader
Figure 11-B602
11-39