Installation; Setting Up; Checking Operation - Canon MP 700 Service Manual

1. INSTALLATION

1.1 Setting Up

• Install the software
Install the software in the computer.
• Select a site of installation
• Unpack the machine, and check the attachments
Make sure none is missing and there is no damage.
• Remove the packing material
Remove all tape and protective material used on the machine. Do not forget to remove the
protective material used in the ADF assembly and LCD display.
• Fit the attachments
• Connect the cable (for MP730)
Connect the telephone line and any necessary external device.
• Turn on the power
Connect the power cord. If the machine is not turn on, press [ON/OFF] to turn on the
machine.
• Load paper
Place a stack of paper in the multi-purpose tray.
• Install the printhead
Remove the protective cap, then install the printhead into the holder.
• Install the ink tanks
Pull the tape and remove the protective cap, then install the ink tanks. After install, align the
printhead.
• Connect the USB cable
Connect the USB cable to complete the computer settings.
• Setting for facsimile (for MP730)
Register the date and time, unit telephone number, and unit name.

1.2 Checking Operation

• Check the level of quality for both reading and printing.
Make a copy, and see that it is free of a fault for both reading and printing.
• Conduct a communications test. (MP730)
Send and receive a fax by connecting to another fax machine, making sure that the image is
normally sent and the received image is normally printed.
What to do when trouble occurs
Very rarely, during use, the display may go out, all the buttons may stop
working, or some other trouble may occur because of strong electrical noise or
a large amount of static. If such trouble occurs, execute 'All clear'. For how,
please refer to Chapter 3, 1.4 All Clear (Action in the Event of Abnormality).
MultiPASS MP730/MP700 Chapter 5: Appendix
5-1