Canon ImageRunner 600 Service Manual page 800

CHAPTER 13 TROUBLESHOOTING
<FEED-ADJ>
Adjusting the Feeding System
Level 3
REGIST Adjusting the Activation Timing for the Registration
Clutch
• A higher setting delays the timing, decreasing the
leading edge margin.
ADJ- Adjusting the Horizontal Registration for Re-Pickup
REFE • If the image is displaced to the rear, enter a lower
setting.
• If the image is displaced to the front, enter a higher
setting.
<CST-ADJ>
Adjusting the Cassette/Manual Feed Tray-Related Items
Level 3
C3- Use it to enter a paper width basic value for the
STMTR cassette 3 (STMTR).
C3-A4R Use it to enter a paper width basic value for the
cassette 3 (A4R).
C4- Use it to enter a paper width basic value for the
STMTR cassette 4 (STMTR).
C4-A4R Use it to enter a paper width basic value for the
cassette 4 (A4R).
MF-A4R Use it to enter a paper width basic value for the
manual feed tray (A4R).
MF-A6R Use it to enter a paper width basic value for the
manual feed tray (A6R).
MF-A4 Use it to enter a paper width basic value for the
manual feed tray (A4).
C3- Use it to set the stacking limit for the cassette 3 (50
LVOL sheets).
C3- Use it to set the stacking limit for the cassette 3 (250
HVOL sheets).
C4- Use it to set the stacking limit for the cassette 4 (50
LVOL sheets).
C4- Use it to set the stacking limit for the cassette 4 (250
HVOL sheets).
13-214
COPYRIGHT © 1999 CANON INC.
Description
Description
CANON imageRUNNER 600 REV.1 JAN. 2000 PRINTED IN U.S.A.
COPIER>ADJUST
Remarks
Range : -50 to 5 (each '23'
causes a shift of 1 mm)
Range : -101 to 100 (each
'23' causes a shift of 1
mm)
Remarks
• If you have replaced the
IP PCB or initialized the
RAM on the IP PCB,
enter the value recorded
on the service label.
• Be sure to execute
FUNCTION>CST if you
have replaced the paper
width sensor.
• If you have replaced the
IP PCB or initialized the
RAM on the IP PCB,
enter the value recorded
on the service label.