Table of Contents
Advertisement
6) Insert the door switch actuator into the door switch assembly.
7) Connect the power plug to the power outlet, and turn on the main power switch and the control
panel power switch.
8) Execute COPIER>FUNCTION>DPC>OFST in service mode.
9) Record the setting of OFST on the service label.
10) Check to make sure that the data lamp on the control panel is off, and turn off the main power
switch.
11) Disconnect the power plug from the power outlet.
12) Detach the potential sensor tester electrode.
13) Connect the power plug to the power outlet, and turn on the main power switch and the control
panel power switch.
COPYRIGHT © 1999 CANON INC.
CANON imageRUNNER 600 REV.1 JAN. 2000 PRINTED IN U.S.A.
CHAPTER 13 TROUBLESHOOTING
13-17
Advertisement
Chapters
Table of Contents
Troubleshooting
