Canon ImageRunner 600 Service Manual page 799

<HV-PRI>
Adjusting the Output of the Primary Charging Assembly
Level 3
GRID Use it to enter an output adjustment value for the grid
bias.
<HV-TR>
Adjusting the Output of the Transfer Charging Assembly/Pre-Transfer Charging Assembly
Level 3
TR-N1 Use it to enter an output adjustment value for the
transfer charging current (for plain paper; single-sheet
or 1st side of double-sided sheet).
TR-N2 Use it to enter an output adjustment value for the
transfer charging current (for plain paper; 2nd side of
double-sided sheet).
PRE-TR Use it to enter an output adjustment value for the pre-
transfer charging current.
<HV-SP>
Adjusting the Output of the Separation Charging Assembly
Level 3
SP-N1 Use it to enter an output adjustment value for
separation charging current (for plain paper; single-
sided sheet or 1st side of double-sided sheet).
SP-N2 Use it to enter an output value for the separation
charging current (for plain paper; 2nd side of double-
sided sheet).
COPYRIGHT © 1999 CANON INC.
Description
Description
Description
CANON imageRUNNER 600 REV.1 JAN. 2000 PRINTED IN U.S.A.
CHAPTER 13 TROUBLESHOOTING
COPIER>ADJUST
Remarks
• If you have replaced the
IP PCB or initialized the
RAM on the IP PCB,
enter the value recorded
on the service label.
Remarks
• If you have replaced the
IP PCB or initialized the
RAM on the IP PCB,
enter the value recorded
on the service label.
Remarks
• If you have replaced the
IP PCB or initialized the
RAM on the IP PCB,
enter the value on the
service label.
13-213