Canon ImageRunner 600 Service Manual page 825

Level 3
DRM- Use it to select idle rotation mode for the
IDL photosensitive drum.
• If the images are distorted or the density is too low
(light), select '1' through '4'.
LDGDT- Enabling/Disabling Collection of Service Data
SW • Specify whether service data may be collected
through the PDL board (accessory for some models).
Service data may be either of the following two types:
1. Service Counter Reading: represents durables and
periodically replaced parts indicated in service mode.
2. Soft Counter Reading: represents the soft
counter reading indicated in service mode.
W-CLN Turning On/Off the Auto Cleaning Mechanism (for
each charging wire)
FIX- Switching the Fixing Heat Discharge Fan (FM2)
FAN-SW Control Mechanism
•
COPYRIGHT © 2000 CANON INC.
Description
Selecting '1' causes the control of the fan after
printing to half-speed control. (If the
environment is a high temperature/humidity one
or the room temperature is 29°C or more, the fan
will rotate at full speed at all times.)
CANON imageRUNNER 600 REV.1 JAN. 2000 PRINTED IN U.S.A.
CHAPTER 13 TROUBLESHOOTING
COPIER>OPTION
Remarks
0: no idle rotation (default)
1: for high humidity,
initiate idle rotation for
30 sec when control
panel soft switch is
turned on
2: for high humidity,
initiate idle rotation for
2 min when control
panel soft switch is
turned on
3: independently of
environment, initiate
idle rotation for 30 sec
when control panel soft
switch is turned on
4: independently of
environment, initiate
idle rotation for 2 min
when control panel soft
switch is turned on
0: disable (default)
1: enable
0: Off
1: On (default)
0: Off (default)
1: On
13-237