Change 1; Change To The Revision 1.0X - Agilent Technologies 4294A Programming Manual

Change 1

The firmware revision 1.0x does not support the following function.
• Saving an internal data array in the touchstione format.
• SCPI Command "MANR" on page 346

Change to the revision 1.0x

Chapter 6 , "Reading/Writing Measurement Data," on page 77
Delete the following sentence in "Saving array as file" on page 83
NOTE
You can save an internal data array in the touchstone format by "SAVDS1P" on page 418.
But you cannot recall the file.
Chapter 8 , "Saving/Recalling a Measurement Result/Measurement Setup," on page
111
Delete the following sentence in "Saving data into a file" on page 112
The following command available for save a data array to a file in the touchstone format.
• "SAVDS1P" on page 418
Chapter 13 , "Application Sample Programs," on page 185
Delete the following section
• "Measurement using scanner" on page 229
Chapter 16 , "GPIB Command Reference," on page 255
Delete the following commands.
• "MANR"(346page)
• "SAVDS1P"(418page)
Appendix A
Manual Changes
Change 1
471