Lmaxs - Agilent Technologies 4294A Programming Manual

LMAXS?

Syntax LMAXS? <numeric 1>
Description
Reads out the measurement parameter value and sweep parameter value of the peak at the
location specified with the order from the left edge of the sweep range among all peaks
within the waveform analysis range set with the "ANARANG" command on page 267.
The peak searched for at the execution of this command satisfies the condition set with the
"THRR" command on page 452. It is not related to the peak definition in the marker search
function. (Query only)
Parameters
Description
Range
Resolution
If the specified parameter is out of the setting range, the operation is the same as when no
peak is detected.
Query response
{numeric 2},{numeric 3}<newline><^END>
Description
If the specified peak is not detected, the readouts of {numeric 2} and {numeric 3} are
3.40282346638529E+038 and 0, respectively.
Corresponding No front panel key is available to execute this function.
key
Chapter 16
<numeric 1>
Location of the peak (the order of the peak from the left)
1 to the number of points
1
{numeric 2}
Measurement parameter value
GPIB Command Reference
LMAXS?
{numeric 3}
Sweep parameter value
343