Smkr{1-7; Smkrauv{1-7 - Agilent Technologies 4294A Programming Manual

GPIB Command Reference

SMKR{1-7}

SMKR{1-7}
Syntax
SMKR{1|2|3|4|5|6|7} {ON|OFF|1|0}
SMKR{1|2|3|4|5|6|7}?
Description
For the active trace (set with the "TRAC" command on page 457), turns on/off a sub
marker (marker number 1 to 7). In the coupled marker mode (set with the "MKRCOUP"
command on page 352), the setting is applied to both the A and B traces regardless of the
active trace setting. The sub marker set to on with this command is displayed at the same
position as the marker. If the marker function is off, executing this command causes an
error and the command is ignored.
Parameters
Query response
{ON|OFF|1|0}<newline><^END>
Corresponding
[Marker]
key
[Marker]
7: OFF

SMKRAUV{1-7}?

Syntax
SMKRAUV{1|2|3|4|5|6|7}?
Description
For the active trace (set with the "TRAC" command on page 457), if the measurement
parameter is a vector value (for COMPLEX Z-Y), reads out the subsidiary readout of the
measurement parameter value at the sub marker position (marker number 1 to 7). (Query
only)
Query response
{numeric}<newline><^END>
If the measurement parameter is a scalar value (for other than COMPLEX Z-Y), 0 is
always read out. If the measurement parameter is a vector value (for COMPLEX Z-Y), the
readout is as follows:
•
•
Corresponding No front panel key is available to execute this function.
key
438
ON or 1
OFF or 0 (initial value)
- SUB MKR - { 1: OFF
-
CREAR SUB MKR
}
If the polar chart format is selected, the phase is read out.
If the complex plane format is selected, reactance (for trace A) or susceptance (for trace
B) is read out.
Description
Turns on a sub marker.
Turns off a sub marker.
| 2: OFF | 3: OFF | 4: OFF
- { | |
1: OFF 2: OFF 3: OFF
| 5: OFF | 6: OFF | 7: OFF
| | |
4: OFF 5: OFF 6: OFF
Chapter 16
}
|