Searminp; Searng - Agilent Technologies 4294A Programming Manual

GPIB Command Reference

SEARMINP

SEARMINP
Syntax
SEARMINP <numeric>
SEARMINP?
Description
For the marker search function for the active trace (set with the "TRAC" command on page
457), if the partial search is enabled (specified to ON with the "PARS" command on page
395), sets the partial search range lower border value to the specified measurement point.
Parameters
If the specified parameter is out of the allowable setting range, the minimum value (if the
lower limit of the range is not reached) or the maximum value (if the upper limit of the
range is exceeded) is set.
Query response
{numeric}<newline><^END>
Corresponding
No front panel key is available to execute this function.
key

SEARNG

Syntax SEARNG {FULL|SEGMENT}
SEARNG?
Description For the active trace (set with the "TRAC" command on page 457), sets the search range for
the list sweep: all segments (entire sweep range) or a single segment. To specify a segment
when the search range is set to a single segment, use the "SEGMNUM" command on page
436.
Parameters
Query response
{FULL|SEGMENT}<newline><^END>
Corresponding
[Search]
key
432
Description Number of the measurement point you want to set to the lower
border value (the number assigned in order from the left edge
assuming that the number of the leftmost measurement point is 1)
Range 1 to the number of points
Initial value 1
Resolution 1
FULL (initial value) Specifies all segments as the search range.
SEGMENT Specifies a single segment as the search range.
-
SEARCH RANGE MENU
<numeric>
Description
- { | }
FULL SEGMENT
Chapter 16