Dmkrprm - Agilent Technologies 4294A Programming Manual

DMKRPRM

Syntax DMKRPRM <numeric>[HZ|MHZ|V|A]
DMKRPRM?
For the active trace (set with the "TRAC" command on page 457), moves the Δ marker on
Description
the trace to the position of the specified sweep parameter value. Note that, for the fixed Δ
marker, the Y axis (vertical axis) value is not changed before and after the move. In the
coupled marker mode (set with the "MKRCOUP" command on page 352), regardless of
the active trace setting, moves the Δ marker of both the A and B traces. If this command is
executed as Query, it reads out the sweep parameter value at the Δ marker position. If the Δ
marker mode is off, executing this command causes an error and the command is ignored.
Parameters
Description
Range
Initial value
Unit
Resolution
If the specified parameter is out of the allowable setting range, the minimum value (if the
lower limit of the range is not reached) or the maximum value (if the upper limit of the
range is exceeded) is set.
Query response {numeric}<newline><^END>
Corresponding
[Marker]
key
Chapter 16
Sweep parameter value you want to specify
Sweep start value to sweep stop value
0
Varies depending on the sweep parameter (refer to the explanation
of unit in "CENT" on page 277).
Varies depending on the sweep parameter (refer to the explanation
of resolution in "CENT" on page 277).
ΔMODE MENU ΔMKR STIMULUS
- -
GPIB Command Reference
DMKRPRM
<numeric>
305