Esnb; Expp - Agilent Technologies 4294A Programming Manual

GPIB Command Reference

ESNB

ESNB
Syntax
ESNB <numeric>
ESNB?
Description
Sets the value of Instrument Event Status Enable Register (Event Status Enable Register
B).
Parameters
If the specified parameter is out of the allowable setting range, the minimum value (if the
lower limit of the range is not reached) or the maximum value (if the upper limit of the
range is exceeded) is set.
Query response
{numeric}<newline><^END>
Corresponding No front panel key is available to execute this function.
key

EXPP

Syntax
EXPP {ON|OFF|1|0}
EXPP?
Description
For the active trace (set with the "TRAC" command on page 457), if the trace
measurement parameter is phase, determines whether to perform the extended phase
display (display in which phases out of the range between -180 and 180 are not rolled up).
If the trace measurement parameter is not phase, executing this command causes an error
and the command is ignored.
Parameters
Query response {1|0}<newline><^END>
Corresponding
[Format]
key
314
Description Value of Instrument Event Status Enable Register
Range 0 to 65535
Initial value 0
Resolution 1
ON or 1
OFF or 0 (initial value)
- EXP PHASE on OFF
<numeric>
Description
Enables the extended phase display.
Disables the extended phase display.
Chapter 16