MKRSTAR
Syntax
MKRSTAR
Description
For the active trace (set with the "TRAC" command on page 457), sets the sweep
parameter value at the marker position as the sweep range start value. To set the start value
of each segment when creating the list sweep table, also use this command. If the marker
function is off, executing this command causes an error and the command is ignored. (No
query)
Corresponding
[Marker→]
key
MKRSTOP
Syntax
MKRSTOP
Description
For the active trace (set with the "TRAC" command on page 457), sets the sweep
parameter value at the marker position as the sweep range stop value. To set the stop value
of each segment when creating the list sweep table, also use this command. If the marker
function is off, executing this command causes an error and the command is ignored. (No
query)
Corresponding
[Marker→]
key
MKRTR
Syntax
MKRTR
Description
For the active trace (set with the "TRAC" command on page 457), sets the range between
the marker and the Δ marker as the partial search range. If the Δ marker mode is off,
executing this command causes an error and the command is ignored. (No query)
Corresponding
[Search]
key
MKRTRMAX
Syntax
MKRTRMAX
Description
For the active trace (set with the "TRAC" command on page 457), sets the marker position
as the partial search range upper border value. If the marker function is off, executing this
command causes an error and the command is ignored. (No query)
Corresponding
[Search]
key
Chapter 16
MKR → START
-
MKR → STOP
-
-
-
SEARCH RANGE MENU
-
SEARCH RANGE MENU
-
GPIB Command Reference
MKRΔ → SEARCH RNG
MKR → MAXIMUM
MKRSTAR
359