Savcal; Savdasc - Agilent Technologies 4294A Programming Manual

GPIB Command Reference

SAVCAL

SAVCAL
Syntax
SAVCAL {ON|OFF|1|0}
SAVCAL?
Description
When saving the internal data array (refer to "Internal data arrays" on page 81) in a file
with the "SAVDASC" command on page 416 and "SAVDDAT" command on page 417,
enables/disables the save of the calibration data array and compensation data array. If user
calibration data has not been measured or inputted using the command, the save file does
not contain values in the calibration data array. This is also applicable to the compensation
data array.
Parameters
Query response
{1|0}<newline><^END>
Corresponding
[Save]
key

SAVDASC

Syntax
SAVDASC <string>
Description Saves the internal data arrays (refer to "Internal data arrays" on page 81) specified to be
saved with the "SAVCAL"(416page), "SAVDAT"(417page), "SAVDTRC"(420page),
"SAVMEM"(420page) and "SAVMTRC"(421page) commands in the ASCII format into
the specified file. The number of saved points is the current number of sweep points. When
specifying a file, you can use a file name including its extension (refer to Table 8-1 on
page 113) or a file name whose extension is omitted. If the extension is not specified, the
file name is the specified file name with the ".TXT" extension added. (No query)
Parameters
If the specified file name has characters that exceed the maximum length, only the string of
up to the maximum length is valid and the remaining characters are ignored.
Corresponding
[Save]
key
416
ON or 1 Enables the save of the calibration data array and compensation
data array.
OFF or 0 Disables the save of the calibration data array and compensation
(initial value) data array.
- -
DATA SELECT CONTENTS
Description Save file name
Range When the extension is not specified: 8 characters or less
When the extension is specified: 12 characters or less
ASCII 
- -
DATA
Description
-
CAL on OFF
<string>
Chapter 16