Filc; Fmt - Agilent Technologies 4294A Programming Manual

FILC

Syntax
FILC <string 1>,<string 2>,<string 3>,<string 4>
Description Copies a file. To specify a file, use a file name including its extension (refer to Table 8-1 on
page 113). (No query)
Parameters
Description
Range
Corresponding
[Save]
key

FMT

Syntax
FMT {LINY|LOGY|POLA|COMP}
FMT?
Description
For the active trace (set with the "TRAC" command on page 457), selects the format to
display the trace. Depending on the setting of the measurement parameter, the settable
display format differs. Trying to select a non-settable display format causes an error and
the command is ignored.
Parameters
For scalar measurement parameters:
LINY (initial value)
LOGY
For vector measurement parameters:
POLA
COMP (initial value) Specifies the complex plane format.
Query response {LINY|LOGY|POLA|COMP}<newline><^END>
Corresponding
[Format]
key
Chapter 16
<string 1>
Copy source
file name
12 characters
or less
(including the
extension)
*1.Each selection item indicates the device name as shown below.
"MEMO": RAM disk (volatile)
"DISK": Diskette
"FLASH": Flash disk (non-volatile)
COPY FILE 
- FILE UTILITIES -
Specifies the linear Y axis format.
Specifies the log Y axis format.
Specifies the polar chart format.
- { | |
LIN LOG COMPLEX
GPIB Command Reference
<string 2> <string 3>
Copy source Copy
device name destination
file name
Select from 12 characters
"MEMO", or less
"DISK", or (including the
*1 extension)
"FLASH"
Description
Description
| }
POLAR
FILC
<string 4>
Copy destination
device name
Select from
"MEMO", "DISK",
*1
or "FLASH"
315