Deleting A Segment; Setting The Trace Color Of Each Segment - Agilent Technologies 4294A Programming Manual

Combining Two or More Sweep Conditions (List Sweep)

Deleting a segment

To delete a segment, use the commands given below.
• "SDEL" on page 425
• "CLEL" on page 279
The "SDEL" command deletes a specified segment from the table (if no table is specified,
then he segment to be worked on at the time of executing the command involved). The
"CLEL" command deletes all segments from the table.

Setting the trace color of each segment

To specify the trace color of each segment, use the command given below.
• "SCOL" on page 424
Chapter 3
Setting Measurement Conditions
45