Numeric Keys; Edit Keys; Program Control Keys - Agilent Technologies 4294A Programming Manual

Numeric keys

The numeric keys are useful for entering numbers and operators. Simply typing an
expression in the command line and pressing the Enter key displays the result at the lower
left part of the screen.
[Enter] This key works the same as the
- The numeric keys work the same as those on the front panel of the
[0] [9]
4294A.
This key has no effect. Pressing this key turns LED on or off, but the
[Num Lock]
numeric keys can be used for entering numeric values only.

Edit keys

HP Instrument BASIC constantly runs in insert mode, so this key has
[Insert]
no effect.
+ Pressing the
[Shift] [Insert]
new line just over the cursor-positioned line (effective in edit mode
only).
Pressing this key deletes a single character over the cursor.
[Delete]
[Shift] + [Delete] Pressing the
the cursor-positioned line (effective in edit mode only).
[End] Pressing this key deletes the cursor-positioned line but leaves the line
number.
[Shift] + [End] Pressing the
characters from the cursor position to the end of that line.
[Home] This key clears the alpha screen. If you are in edit mode, this key exits
the edit mode.

Program control keys

Program control keys exert control over program execution.
Pressing this key or pressing the
[Pause/Break]
key temporarily stops program execution. If you carry out the key
operation
4294A, the temporary stop is canceled.
Pressing the
key together stops program execution. To resume executing the
program, carry out the key operation
front panel of the 4294A.
[Ctrl] + [Pause/Break] Pressing the
resets program execution without erasing the program from memory
(BASIC RESET).
Pressing the
stops the execution of the program involved in I/O operation. If the
System hangs up during I/O operation, press the
holding down the
Chapter 11
[Enter]
key while holding down the
[Insert]
[Delete] key while holding down the
[End] key while holding down the
key while holding down the
[F4]
[System] - IBASIC - Continue
key while holding down the
[F4]
[System]
[Pause/Break] key while holding down the
[F5] key while holding down the
key instead of pressing the
[Alt]
Using HP Instrument BASIC
Keyboard
key.
key inserts a
[Shift]
[Shift] key deletes
[Shift] key deletes
[Alt]
on the front panel of the
key and the
[Shift] [Alt]
- IBASIC - Run on the
[Ctrl] key
[Alt] key temporarily
[F5] key while
key
[Pause/Break]
155