Seatarg; Seatargl - Agilent Technologies 4294A Programming Manual

SEATARG

Syntax SEATARG <numeric>[DEG|RAD|OHM|SIE|H|F|PCT]
SEATARG?
Description For the active trace (set with the "TRAC" command on page 457), sets the target value
(value in the Y axis direction) when performing the target search in the marker search
function. In the Δ marker mode, the value set with this command is dealt as a relative value
form the Δ marker. Therefore, to set the target value, use a relative value from the Δ
marker.
Parameters
Description
Range
Initial value
Unit
If the specified parameter is out of the allowable setting range, the minimum value (if the
lower limit of the range is not reached) or the maximum value (if the upper limit of the
range is exceeded) is set.
Query response {numeric}<newline><^END>
Corresponding
[Search]
key

SEATARGL

Syntax
SEATARGL {ON|OFF|1|0}
SEATARGL?
Description
For the active trace (set with the "TRAC" command on page 457), enables/disables the
display of the line indicating the target value (target line) when performing the target
search in the marker search function.
Parameters
ON or 1
OFF or 0
(initial value)
Query response {1|0}<newline><^END>
Corresponding
[Search]
key
Chapter 16
Target value at the execution of the target search
-100M to 100M
0
Varies depending on the measurement parameter (refer to the
explanation of unit in "SCAL" on page 423).
- -
TARGET TARGET VALUE
Enables the display of the target line.
Disables the display of the target line.
- -
TARGET LINE on OFF
GPIB Command Reference
<numeric>
Description
SEATARG
433