Aver; Averfact; Averrest - Agilent Technologies 4294A Programming Manual

AVER

Syntax AVER {ON|OFF|1|0}
AVER?
Description Enables/disables the sweep averaging function.
Parameters
ON or 1
OFF or 0 (Initial value) Disables the sweep averaging function.
Query response
{1|0}<newline><^END>
Corresponding
[Bw/Avg]
key

AVERFACT

Syntax
AVERFACT <numeric>
AVERFACT?
Description Sets the averaging factor of the sweep averaging function.
Parameters
Description
Range
Initial value
Resolution
If the specified parameter is out of the allowable setting range, the minimum value (if the
lower limit of the range is not reached) or the maximum value (if the upper limit of the
range is exceeded) is set.
Query response
{numeric}<newline><^END>
Corresponding
[Bw/Avg]
key

AVERREST

Syntax
AVERREST
Description Resets the data count used in averaging calculation of the sweep averaging function to 0.
Measured data before the execution of this command is not used in averaging calculation.
If this command is executed while the 4294A is performing a sweep, it is restarted. (No
query)
Corresponding
[Bw/Avg]
key
Chapter 16
Enables the sweep averaging function.
-
AVERAGING on OFF
Averaging factor
1 to 256
16
1
- AVERAGING FACTOR
-
AVERAGING RESTART
GPIB Command Reference
Description
<numeric>
AVER
269