Limsdel; Limsdon - Agilent Technologies 4294A Programming Manual

LIMSDEL

Syntax LIMSDEL [<numeric>]
Description
In the creation/edit of the limit line table, deletes the specified segment (if no segment is
specified, the segment specified as the edit target) from the table.
The segment number of each segment after the deleted segment decreases by 1. As a result,
the segment, whose number was changed to the same number as the deleted segment, is set
to the edit target. Note that, if the last segment is deleted, the segment immediately before
the deleted segment is set to the edit target. You can set any segment to the edit target using
the "LIMSEGM" command on page 333.
During segment edit (after the execution of the "LIMSADD" command on page 330 or
"LIMSEDI" command on page 332 and before the execution of the "LIMSDON"
command on page 331), executing this command causes an error and the command is
ignored.
If the creation/edit of the limit line table has not been started, executing this command
automatically starts table creation/edit and then deletes the segment. (No query)
NOTE Executing the "LIMEDONE" command on page 326 brings the created/edited limit line
table to take effect.
Parameters
Description
Range
Resolution
If the specified parameter is out of the allowable setting range, the minimum value (if the
lower limit of the range is not reached) or the maximum value (if the upper limit of the
range is exceeded) is set.
Corresponding
[System]
key

LIMSDON

Syntax
LIMSDON
Description
In the creation/edit of the limit line table, finishes segment creation/edit. Executing this
command brings the created/edited segment to take effect. (No query)
NOTE Executing the "LIMEDONE" command on page 326 brings the created/edited limit line
table to take effect.
Corresponding
[System]
key
Chapter 16
Segment number you want to delete
1 to the number of the segments in the limit line table
1
- LIMIT TEST - EDIT LIMIT LINE
- LIMIT TEST - EDIT LIMIT LINE
GPIB Command Reference
<numeric>
- DELETE
- EDIT - done
LIMSDEL
331