Manr - Agilent Technologies 4294A Programming Manual

GPIB Command Reference

MANR

MANR
Syntax
MANR <value 1>,<value 2>
MANR?
Description
When the manual sweep function is on, sets a measurement range. You need to turn on the
manual sweep with the "MANS"(347page) command before executing this command.
Parameters
NOTE When both <value 1> and <value 2> are 0, the measurement range for the manual sweep is
set to the measurement point specified with the "MANP" on page 345 command.
Only when the specified parameters satisfy the condition value 1 < value 2, the sweep
range is set properly. If this condition is not satisfied, the following occurs.
Query response
{value 1},{value 2}<newline><^END>
Equivalent key No equivalent key is available on the front panel.
346
Description The number of the sweep start
point
Measurement point numbers are assigned in order from the left
end assuming that the left end measurement point is 1.
Range 1 to the number of measurement points or both <value 1> and
<value 2> are 0.
Preset value 0
Resolution 1
Condition
value ≤ 0
When both value 1 and value 2 are 0, they do not change. The
sweep is performed for the point specified with the
"MANP"(345page) command.
Otherwise, 1 is set.
value > the number The value is set to the number of measurement points.
of measurement
points
value 1 ≥ value 2
Value 1 is set to the value of value 2. The sweep is performed for
the point specified with the "MANP"(345page) command.
<value 1>
The number of the sweep stop
point
0
1
Change of setting
<value 2>
Chapter 16