Reading A Program (Get) - Agilent Technologies 4294A Programming Manual

Reading a Program (GET)

Here follows the procedure of reading a program from the storage unit.
Step 1. To read a program from a floppy disk, inert it into the floppy disk drive.
Step 2. Reserve a BASIC area on the screen. For the procedure, see "Reserving an Area for BASIC
on the Screen" on page 139.
Step 3. Decide on which storage unit to use a floppy disk, RAM disk (volatile), or flash disk
(non-volatile).
If you decide on it by use of the front panel, follow the procedure given below.
1. Carry out the key operation given below.
-
[System] IBASIC
2. Press one of the softkeys
(flash disk).
MEMORY
If you use the keyboard, enter one of the following, the press the
• To decide on a floppy disk
MSI ":INTERNAL,4"
• To decide on a RAM disk
MSI ":MEMORY,0"
• To decide on a flash disk
MSI ":INTERNAL1,5"
Step 4. Type the following on the keyboard, then press the
GET "file name"
Chapter 11
- -
more 1/3 MASS STORE[]
FLOPPY (floppy disk),
[Enter]
Using HP Instrument BASIC
Reading a Program (GET)
MEMORY (RAM disk), and
key.
[Enter]
key.
FLASH
147