Powmod; Prep; Pres - Agilent Technologies 4294A Programming Manual

GPIB Command Reference

POWMOD

POWMOD
Syntax
POWMOD {VOLT|CURR}
POWMOD?
Description
Selects voltage or current to set the oscillator (OSC) power level. To set the oscillator
power level setting method of each segment when creating the list sweep table, use this
command.
Parameters
Note that, if you use this command to create a segment, the initial value when creating
segment 1 is the current setting method selection value and the initial value when creating
an additional segment is the setting method selection value of the previous segment.
Query response
{VOLT|CURR}<newline><^END>
Corresponding
[Source]
key

PREP

Syntax PREP
Description
When the measurement results are listed as a result of the execution of the "LISV"
command on page 341, displays the previous page of the list. To display the next page,
execute the "NEXP" command on page 363.(No query)
Corresponding
[Copy]
key

PRES

Syntax PRES
Description
Resets to the preset state. The preset state is almost the same as that of the reset using the
"*RST" command on page 260, though there are some differences shown bellow. (No
query)
•
•
Corresponding
[Preset]
key
404
VOLT (initial value) Specifies the voltage setting.
CURR Specifies the current setting.
- OSC UNIT [ ]
- SELECT CONTENTS
The sweep mode is set to CONT.
The HP Instrument BASIC is not reset.
Description
- LIST VALUE - PREV PAGE
Chapter 16