Manual Changes - Agilent Technologies 4294A Programming Manual

Manual Changes

Manual Changes
Manual Changes
To adapt this manual to your Agilent 4294A, refer to Table A-1 and Table A-2.
Table A-1 Manual Changes by Serial Number
Table A-2 Manual Changes by Firmware Version
Agilent Technologies uses a two-part, ten-character serial number that is stamped on the
serial number plate (see Figure A-1). The first five characters are the serial prefix and the
last five digits are the suffix.
Execute the "*IDN?" command on page 259 to check the firmware version.
Figure A-1 Example of Serial Number Plate
470
Serial Prefix or Number
Version
Rev 1.10
Rev 1.11
Make Manual Changes
Make Manual Changes
"Change 1" on page 471
"Change 2" on page 472
Appendix A