Softkeys Accessed From [Shift]+[F9] Key - Agilent Technologies 4294A Programming Manual

Softkeys accessed from
Pressing the [F9] key while holding down the
for controlling a program. Pressing this softkey allows you to run a command or to
generate program source code instead of keyboard entries. Each menu item is described
below.
Step Executes the program line by line. Useful for debugging.
Continue Cancels the temporary stop of the program.
Runs the program.
Run
Runs the instruction on the current line, then temporarily stops running
Pause
the program.
Stop Stops running the current line and subsequent lines. Pressing
allows you to run the program from the beginning over again.
Edit Turns edit mode ready.
Displays softkeys defined by the program.
ON KEY LABELS
Generates the character string "CAT " in the BASIC command line.
CAT
The CAT command lists file names held in the disk.
Generates the character string "SAVE """ in the BASIC command line.
SAVE
The SAVE command saves a program in the form of ASCII file.
Generates the character string "RE-SAVE """ in the BASIC command
RE-SAVE
line. RE-SAVE overwrites a specified file with the program. Use this
to update an old file.
Generates the character string "GET """ in the BASIC command line.
GET
The GET command loads a specified ASCII file and reads it into
editor's memory.
Generates the character string "PURGE """ in the BASIC command
PURGE
line. The PURGE command erases a specified file.
INITIALIZE Generates the character string "INITIALIZE " in the BASIC command
line. The INITIALIZE command formats the disk so that the disk turns
ready for use. If you execute this command, the contents of the disk
will be fully lost.
Displays the menu for choosing a BASIC storage unit.
MASS STORE []
SCRATCH Generates the character string "SCRATCH " in the BASIC command
line. If you press the
the editor will be erased from memory.
RENUMBER Generates the character string "REN " in the BASIC command line. If
you press the
re-numbered.
LIST Generates the character string "LIST " in the BASIC command line.
The LIST command outputs a program listing on the screen.
COMMAND ENTRY Displays the softkeys to be used for entering BASIC commands.
CLEAR I/O Stops I/O operation currently being carried out.
Resets IBASIC (BASIC reset).
RESET LABELS
Chapter 11
+ key.
[Shift] [F9]
[Shift] key calls the BASIC menu to be used
key in succession, the program handled in
[Enter]
key in succession, the program line will be
[Enter]
Using HP Instrument BASIC
Keyboard
Run
157