Display Of Dut Connection And Measurement Result; Dut Connection And Measurement; How To Change Measurement Point - Agilent Technologies Twelfth 4287A RF LCR Operation Manual

Display of DUT Connection and Measurement Result

DUT connection and measurement

Step 1. Connect the DUT according to the Operation Manual for the test fixture.
The measurement result is displayed as shown in Figure 3-28.
Figure 3-28 Measurement result display (measurement point number = 1)

How to change measurement point

In Figure 3-28, the measurement result is only displayed for the 1-MHz point among the
four measurement points (1 MHz, 10 MHz, 100 MHz and 1 GHz) set according to "How to
set the measurement point (frequency/averaging factor/oscillator level)" on page 54.
Follow these steps to change the measurement point on which you want to perform
measurements and display results.
Step 1. Press the
panel. The Stml Select softkey menu appears on the right side of the display.
Step 2. Turn the rotary knob (
move the cursor in the softkey menu to the
Step 3. Press the rotary knob (
the display.
Step 4. Turn the rotary knob (
corresponding to the desired measurement point number (
Chapter 3
Display of DUT Connection and Measurement Result
key on the measurement block (MEASUREMENT) of the front
[Stml Select]
) in the navigation block (NAVIGATION) on the front panel to
) to display the POINT No.[ ] softkey menu on the right side of
) to move the cursor in the softkey menu to the softkey
Learning Basic Operations
POINT No.[ ] key.
POINT 4 in this case).
69