Pkdltx - Agilent Technologies 4294A Programming Manual

PKDLTX

Syntax PKDLTX <numeric>[HZ|MHZ|V|A]
PKDLTX?
For the active trace (set with the "TRAC" command on page 457), sets the ΔX value (refer
Description
to Figure 7-1 on page 97) parameter to define the peak searched for in the marker search
function.
Parameters
OSC level (voltage)
OSC level (current)
dc bias level (voltage)
dc bias level (current)
If the specified parameter is out of the allowable setting range, the minimum value (if the
lower limit of the range is not reached) or the maximum value (if the upper limit of the
range is exceeded) is set.
Query response
{numeric}<newline><^END>
Corresponding
[Search]
key
Chapter 16
Description
Range
When the sweep
parameter is Initial value 500E3
frequency
Unit
Range
When the sweep
parameter is Initial value 5E-3
Unit
Range
When the sweep
parameter Initial value 100E-6
Unit
Range
When the sweep
parameter is Initial value 0.4
Unit
Range
When the sweep
parameter is Initial value 1E-3
Unit
- -
PEAK PEAK DEF MENU
GPIB Command Reference
<numeric>
ΔX value
0 to 110E6
Hz
0 to 1
V (volt)
0 to 20E-3
A (ampere)
0 to 80
V (volt)
0 to 200E-3
A (ampere)
PEAK DEF: ΔX
-
PKDLTX
399