Mkrlimstar; Mkrlimstop - Agilent Technologies 4294A Programming Manual

MKRLIMSTAR

Syntax MKRLIMSTAR
Description
In the creation/edit of the limit line table, sets the sweep parameter value at the marker
position as the sweep parameter value of the segment start point. This command is used,
together with the "MKRLIMVSTAR" command on page 354, usually when setting the
sweep parameter value and measured value at the marker position as the sweep parameter
value and limit central value of the segment start point, respectively.
If segment creation/edit has not been started, executing this command automatically starts
the edit of the edit target segment and then sets the sweep parameter value of the start
point.
If the creation/edit of the limit line table has not been started, executing this command
automatically starts table creation/edit, starts the edit of the edit target segment, and then
sets the sweep parameter value of the start point.
If the marker function is off, executing this command causes an error and the command is
ignored. (No query)
Corresponding
[System]
key

MKRLIMSTOP

Syntax
MKRLIMSTOP
Description In the creation/edit of the limit line table, sets the sweep parameter value at the marker
position as the sweep parameter value of the segment stop point. This command is used,
together with the "MKRLIMVSTOP" command on page 354, usually when setting the
sweep parameter value and measured value at the marker position as the sweep parameter
value and limit central value of the segment stop point, respectively.
If segment creation/edit has not been started, executing this command automatically starts
the edit of the edit target segment and then sets the sweep parameter value of the stop point.
If the creation/edit of the limit line table has not been started, executing this command
automatically starts table creation/edit, starts the edit of the edit target segment, and then
sets the sweep parameter value of the stop point.
If the marker function is off, executing this command causes an error and the command is
ignored. (No query)
Corresponding
[System]
key
Chapter 16
- -
LIMIT TEST EDIT LIMIT LINE
- LIMIT TEST - EDIT LIMIT LINE
GPIB Command Reference
more 2/3 - MKR → START
- - -
EDIT more 1/3
more 2/3 - MKR → STOP
- EDIT - more 1/3 -
MKRLIMSTAR
353