Seam; Seanpk; Seanpkl - Agilent Technologies 4294A Programming Manual

SEAM

Syntax SEAM {MAX|MIN|TARG|PEAK|OFF}
SEAM?
Description For the active trace (set with the "TRAC" command on page 457), executes the specified
search function. If no search target is detected, the message saying "Not detected" is
displayed (no error occurs).
Parameters
MAX
MIN
TARG
PEAK
OFF (initial value)
Query response
{MAX|MIN|TARG|PEAK|OFF}<newline><^END>
Corresponding
[Search]
key

SEANPK

Syntax SEANPK
Description For the active trace (set with the "TRAC" command on page 457), moves the marker to the
next smaller peak of the last detected peak. If no peak is detected, the message saying "Not
detected" is displayed (no error occurs). If the marker function is off, executing this
command causes an error and the command is ignored. (No query)
Corresponding
[Search]
key

SEANPKL

Syntax
SEANPKL
Description
For the active trace (set with the "TRAC" command on page 457), moves the marker to a
peak to the left of the current marker position. If no peak is detected, the message saying
"Not detected" is displayed (no error occurs). If the marker function is off, executing this
command causes an error and the command is ignored. (No query)
Corresponding
[Search]
key
Chapter 16
Specifies the maximum value search.
Specifies the minimum value search.
Specifies the target search. The target closest to the current marker
position is searched for.
Specifies the peak search. The maximum peak (minimum peak if
the peak has been defined as negative peak) is searched for.
Turns off the search function.
TRAGET 
- { MAX | MIN | |
- -
PEAK NEXT PEAK
- PEAK - NEXT PEAK LEFT
GPIB Command Reference
Description
PEAK 
}
SEAM
427