Addrip - Agilent Technologies 4294A Programming Manual

ADDRIP

Syntax ADDRIP <1st>,<2nd>,<3rd>,<4th>
ADDRIP?
Description Sets the LAN IP address of the 4294A when using the 4294A connected to LAN.
NOTE To bring the setting of the changed IP address to take effect, reboot (turn off and then on
again) the 4294A after the setting.
Parameters
Description 1st number of IP
Range
Initial value 0
Resolution 1
If the specified parameter is out of the allowable setting range, the minimum value (if the
lower limit of the range is not reached) or the maximum value (if the upper limit of the
range is exceeded) is set.
Query response
{1st},{2nd},{3rd},{4th}<newline><^END>
Corresponding
[Local]
key
Chapter 16
*1
<1st>
address
0 to 255
*1.For example, if the IP address is 1.10.100.50, <1st> is 1, <2nd> is 10,
<3rd> is 100, and <4th> is 50.
- -
IP ADDRESS 1st, 2nd, 3rd, 4th
GPIB Command Reference
*1
<2nd> <3rd>
2nd number of IP 3rd number of IP
address address
0 to 255 0 to 255
0 0
1 1
ADDRIP
*1 *1
<4th>
4th number of IP
address
0 to 255
0
1
265