A Sample Program For Setting Measurement Conditions - Agilent Technologies 4294A Programming Manual

A Sample Program for Setting Measurement Conditions

A Sample Program for Setting Measurement Conditions
The following is a sample program for setting measurement conditions. The program is
given the file name setup.bas and stored on the sample program disk.
This program resets the Agilent 4294A, then makes the settings shown below, and finally
delivers the completion message when the settings are completed.
Item
Adaptor setting
Measurement parameter
Limit of dc bias output
dc bias range
Type of sweep
How to indicate list sweeps
Separation of trace A and trace B
Whether to lay a trace over another
Trace A Trace to be displayed
Display format
The maximum value to be displayed on
the screen
The minimum value to be displayed on
the screen
Trace B Trace to be displayed
Display format
Position of the grid's reference line
Value of the grid's reference line
Value for one graduation of the grid
Unit of indicating a phase
Whether to turn on of off the extended
phase indication
Setting in the list sweep table
Start frequency
Stop frequency
Number of measurement points
Oscillator output setting mode
Oscillator output level
dc bias output mode
dc bias output level
Measurement bandwidth
Number of points used in averaging
Trace color
Chapter 3
Setting Measurement Conditions
No adaptor
A: Impedance amplitude
B: Impedance phase
15 V
10 mA range
List sweep (refer to a separate table)
Segment by segment
Turned on
Turned on
DATA
Log Y axis format
1E-3
1E-9
DATA
Linear Y axis format
5
0
72
° (degrees)
Turned on
Segment 1 Segment 2
1 MHz 20 MHz
20 MHz 40 MHz
21 51
In voltage In voltage
1 V 1 V
Constant voltage Constant voltage
10 V 10 V
Bandwidth 1 Bandwidth 5
1 4
Pen 1 Pen 2
Setting
Segment 3
40 MHz
100 MHz
21
In voltage
1 V
Constant voltage
10 V
Bandwidth 1
1
Pen 3
49