Program[:Selected]:Wait; Commands Starting With :Program:explicit - Agilent Technologies 4294A Programming Manual

GPIB Command Reference

:PROGram[:SELected]:WAIT

:PROGram[:SELected]:WAIT
Syntax
:PROGram[:SELected]:WAIT
:PROGram[:SELected]:WAIT?
Description
Makes the setting so that the 4294A accepts no commands until the status of the program
on the 4294A Instrument BASIC editor becomes STOP or PAUSE from RUN.
If this command is executed as Query, 1 is read out when the program status changes from
RUN to STOP or PAUSE.
Query response
{1}<newline><^END>
Corresponding No front panel key is available to execute this function.
key

Commands starting with :PROGram:EXPLicit

The commands starting with :PROGram:EXPLicit have the same function as those starting
with :PROGram[:SELected]. The below table shows their relationship.
If you change the definition of the program name with the
":PROGram[:SELected]:NAME" command on page 466, the "PROG" part in the table
must be replaced with the program name.
468
Commands starting with
:PROGram:EXPLicit:
:PROGram:EXPLicit:DEFine "PROG"
:PROGram:EXPLicit:DELete "PROG"
:PROGram:EXPLicit:EXECute "PROG"
:PROGram:EXPLicit:MALLocate "PROG"
:PROGram:EXPLicit:NAME "PROG"
:PROGram:EXPLicit:NUMBer "PROG"
:PROGram:EXPLicit:STATe "PROG"
:PROGram:EXPLicit:STRing "PROG"
:PROGram:EXPLicit:WAIT "PROG"
Commands starting with
:PROGram[:SELected]:
:PROGram[:SELected]:DEFine
:PROGram[:SELected]:DELete:[SELected]
:PROGram[:SELected]:EXECute
:PROGram[:SELected]:MALLocate
:PROGram[:SELected]:NAME
:PROGram[:SELected]:NUMBer
:PROGram[:SELected]:STATe
:PROGram[:SELected]:STRing
:PROGram[:SELected]:WAIT
Chapter 16