Agilent Technologies 4294A Programming Manual page 141

Inserting characters
In edit mode, character insertion mode is constantly ready. What you type on the keyboard
is inserted at the cursor position (not in overwrite mode).
Moving the cursor
You can move the cursor either leftward or rightward by the key operation given below.
Front panel operation
Turn the rotary knob.
Scrolling lines
You can scroll lines up or down by the key operation given below.
Front panel operation
Press the step keys (
Scrolling pages
Pressing either the
[Page Up]
scroll one page up or down.
Moving to a specified line
The operation given below allows you to move the cursor to a line you specify.
Step 1. Carry out the following operation on the front panel.
[System] - IBASIC
Step 2. Enter a line number by use of either the front panel or the keyboard, then press the
If labels are defined in the program, you can specify the move destination by the label
instead of the line number.
Moving to the beginning or to the tail end of a program.
Press either the [↑] key or the
allows you to move either to the beginning or to the tail end of the program.
Inserting, deleting, or restoring a line
Pressing the
[Insert]
line just over the current cursor-positioned line.
Pressing the
[Delete]
cursor-positioned line.
Carrying out the following key operation on the front panel allows you to restore the line
you last deleted.
-
[System] IBASIC
Chapter 11
Press either the
or ). Press either the
[↑] [↓]
key or the
[Page Down]
- GOTO LINE
[↓] key while holding down the
key while holding down the
key while holding down the
-
RECALL LINE
Using HP Instrument BASIC
Editing a Program
Keyboard operation
key or the
[←] [→]
Keyboard operation
key or the
[↑] [↓]
key on the keyboard allows you to
[Shift] key on the keyboard
key on the keyboard inserts a new
[Shift]
key deletes the current
[Shift]
key.
.
[Enter] .
141