Limdstar - Agilent Technologies 4294A Programming Manual

LIMDSTAR

Syntax LIMDSTAR <numeric>[DEG|RAD|OHM|SIE|H|F|PCT]
LIMDSTAR?
Description In the creation/edit of the limit line table, sets the limit width (=upper value - central value)
of the start point of each segment (specified with the "LIMSTAR" command on page 334).
Use this command, together with the "LIMVSTAR" command on page 339, when
specifying the limits using the central value and the width.
If segment creation/edit has not been started, executing this command automatically starts
the edit of the edit target segment and then sets the limit width of the start point.
If the creation/edit of the limit line table has not been started, executing this command
automatically starts table creation/edit, starts the edit of the edit target segment and then
sets the limit width of the start point.
Parameters
Description
Range
Initial value
Unit
If the specified parameter is out of the allowable setting range, the minimum value (if the
lower limit of the range is not reached) or the maximum value (if the upper limit of the
range is exceeded) is set.
Query response
{numeric}<newline><^END>
Corresponding
[System]
key
Chapter 16
Limit width of the segment start point
-1E9 to 1E9
When creating segment 1: 0
When creating an additional segment: Set value of the previous segment
Varies depending on the measurement parameter (refer to the explanation
of unit in "SCAL" on page 423).
- -
LIMIT TEST EDIT LIMIT LINE
GPIB Command Reference
<numeric>
-
EDIT - DELTA LIMIT
LIMDSTAR
325