Anarang - Agilent Technologies 4294A Programming Manual

ANARANG

Syntax ANARANG <numeric 1>,<numeric 2>[HZ|MHZ|V|A]
ANARANG?
Description Sets the analysis range when performing waveform analysis using the waveform analysis
command. You specify the analysis range using the lower limit and the upper limit (or, the
upper limit and the lower limit). If the lower/upper limit does not match with any
measurement point sweep parameter values, the analysis range lower limit is set to the
minimum measurement point larger than the specified value and the analysis range upper
limit is set to the maximum measurement point smaller than the specified value.
If the sweep condition setting is changed, the analysis range is set to the entire sweep
range. If the sweep range setting is zero span, the analysis range is always the entire sweep
range (all measurement points).
Parameters
When the sweep
When the sweep
parameter is OSC
When the sweep
parameter is OSC
When the sweep
parameter is dc bias
When the sweep
parameter is dc bias
If the specified parameter is out of the allowable setting range, the minimum value (if the
lower limit of the range is not reached) or the maximum value (if the upper limit of the
range is exceeded) is set.
Query response {numeric 1},{numeric 2}<newline><^END>
Corresponding
No front panel key is available to execute this function.
key
Chapter 16
Description
Range
Initial value 40
parameter is Unit
frequency
Resolution 1E-3
Initial value 0
Unit
level (voltage)
Resolution 1E-3
Initial value 40E-6
Unit
level (current)
Resolution 1E-6
Initial value 0
Unit
level (voltage)
Resolution 1E-3
Initial value 0
Unit
level (current)
Resolution 20E-6
GPIB Command Reference
<numeric 1>
Analysis range lower Analysis range upper
limit (or upper limit) limit (or lower limit)
Current sweep range Current sweep range
110E6
Hz Hz
1E-3
1
V (volt) V (volt)
1E-3
20E-3
A (ampere) A (ampere)
1E-6
0
V (volt) V (volt)
1E-3
0
A (ampere) A (ampere)
20E-6
ANARANG
<numeric 2>
267