Segm - Agilent Technologies 4294A Programming Manual

SEGM

Syntax SEGM <numeric>
SEGM?
Description Sets the execution target segment used when no segment is specified at the execution of the
"SADD" command on page 415, "SDEL" command on page 425 and "SEDI" command
on page 434. The setting of the execution target segment, when the creation/edit of the list
sweep table is finished, is initialized.
If the creation/edit of the list sweep table is not started, executing this command
automatically starts table creation/edit and then sets the execution target segment.
Parameters
Description
Range
Initial value
Resolution
If the specified parameter is out of the allowable setting range, the minimum value (if the
lower limit of the range is not reached) or the maximum value (if the upper limit of the
range is exceeded) is set.
Query response
{numeric}<newline><^END>
If the creation/edit of the list sweep table is not started, 0 is always read out.
Corresponding
[Sweep]
key
Chapter 16
Segment number you want to specify as the edit target
1 to the number of segments in the list sweep table
Segment number of the last line in the list sweep table
1
- EDIT LIST - SEGMENT
GPIB Command Reference
<numeric>
SEGM
435