Agilent Technologies 4294A Programming Manual page 216

Application Sample Programs
Measuring Magnetic Materials
Figure 13-5 Example of the Result of Executing the Program of Example 13-4
The program is described in detail below:
Lines 100 to 110
Lines 120 to 130
Line 150
Lines 170 to 230
Line 260
Line 270
Line 290
Line 300
Line 310
Line 320
Lines 350 to 860
216
Sets the GPIB address and select code.
Assigns the upper half of the LCD screen to measurement result
display and the lower half to the HP Instrument BASIC, and stops the
sweep.
Stores the permeability of vacuum into the U0 variable.
Displays the message at the start of the program.
Passes control to a subroutine named Adapter_setup to set up the
adapter.
Passes control to a subroutine named Fixt_compen to execute fixture
compensation.
Passes control to a subroutine named Input_size to set the outside
diameter, inside diameter, and height of the MUT.
Passes control to a subroutine named Sweep to perform measurement.
Passes control to a subroutine named Calc to calculate each parameter.
Jumps to the Display line and displays each parameter.
The Adapter_setup subroutine.
Lines 360 to 420: Sets 42942A as the adapter and asks you if you
want to perform adapter setup.
Lines 440 to 460: After reset, makes the setting to use SRQ.
Lines 480 to 500: After clearing the register, sets the branch
destination for an SRQ interrupt, and enables the SRQ interrupt.
13