Setting The Limit Test Functions; Making/Editing A Segment - Agilent Technologies 4294A Programming Manual

Setting Measurement Conditions

Setting the Limit Test Functions

Setting the Limit Test Functions
To turn on or off the limit test functions, use the command given below.
•
To use the limit test functions, you need to make a limit line table, which includes the limits
of sweep ranges (segments) defined by start points and endpoints. When beginning and
finishing a table, send the commands given below.
•
•
NOTE With the "LIMEDONE" command not executed, the settings resulting from making,
editing, and deleting with the commands given below will not take effect, and the limit line
table is left as it was before execution of the "EDITLIML" command.

Making/editing a segment

To make a new segment, use the command given below. This command adds a segment
that is ready to be edited.
•
To set a segment's range (its start point and end point), use the commands given below.
•
•
•
•
To set a range for limiting start points, use the commands given below.
•
•
•
•
•
To set a range for limiting endpoints, use the commands given below.
•
•
•
•
•
46
"LIMITEST" on page 328
"EDITLIML" on page 310
"LIMEDONE" on page 326
"LIMSADD" on page 330
"LIMSTAR" on page 334
"MKRLIMSTAR" on page 353
"LIMSTOP" on page 336
"MKRLIMSTOP" on page 353
"LIMUSTAR" on page 337
"LIMLSTAR" on page 328
"LIMVSTAR" on page 339
"MKRLIMVSTAR" on page 354
"LIMDSTAR" on page 325
"LIMUSTOP" on page 338
"LIMLSTOP" on page 329
"LIMVSTOP" on page 340
"MKRLIMVSTOP" on page 354
"LIMDSTOP" on page 326
Chapter 3