The Agilent 4294A Commands; Accud; Addrcont - Agilent Technologies 4294A Programming Manual

The Agilent 4294A commands

This section describes the GPIB commands specific to the 4294A.

ACCUD

Syntax ACCUD {ON|OFF|1|0}
ACCUD?
Description
Enables/disables the display mode to accumulate traces in which they are not cleared at
each sweep.
Parameters
ON or 1
OFF or 0
(Initial value)
Query response
{1|0}<newline><^END>
Corresponding
[Display]
key

ADDRCONT

Syntax ADDRCONT <numeric>
ADDRCONT?
Description Sets the GPIB address of the controller of the 4294A.
Parameters
Description
Range
Initial value
Resolution
If the specified parameter is out of the allowable setting range, the minimum value (if the
lower limit of the range is not reached) or the maximum value (if the upper limit of the
range is exceeded) is set.
Query response {numeric}<newline><^END>
Corresponding
[Local]
key
Chapter 16
Enables the trace accumulating display.
Disables the trace accumulating display (the trace is cleared at each
sweep and only the latest trace is displayed).
-
ACCUMULATE on OFF
GPIB address of the controller
1 to 30
21
1
- ADDRESS: CONTROLLER
GPIB Command Reference
Description
<numeric>
ACCUD
263