Connecting With Lan - Agilent Technologies 4294A Programming Manual

Using LAN
Getting Ready for Using LAN
Setting a gateway IP address
Here follows the way of setting a gateway IP address.
Step 1. Press the [ Local ] key in the INSTRUMENT STATE block on the front panel, and press the
GATEWAY ADRESS
Step 2. Press the key, and enter the first number of the gateway IP address delimited by a
1st
period.
Step 3. Press the key, the
2nd
and the fourth numbers of the gateway IP address delimited by a period.
Step 4. Press the key.
done
To make settings with the GPIB command, use the command given below.
• "ADDRGW" on page 264
Setting a sub-net mask
Here follows the way of setting a sub-net mask.
Step 1. Press the [ Local ] key in the INSTRUMENT STATE block on the front panel, and press the
SUBNET MASK
Step 2. Press the key, and enter the first number of the sub-net mask delimited by a period.
1st
Step 3. Press the key, the
2nd
and the fourth numbers of the sub-net mask delimited by a period.
Step 4. Press the key.
done
To make settings with the command, use the command given below.
• "SUBNET" on page 447
Displaying the MAC address
In the event that you need to look up the MAC address (a unique address assigned to the
device) of the 4294A, follow the steps given below, the MAC address will be displayed on
the LCD screen.
Step 1. Press the [
System
the
DIAGNOSTIC TEST
Step 2. Pressing the
MAC ADDRESS
LCD screen.

Connecting with LAN

Use a 10Base-T twisted pair (Ethertwist) cable to connect the LAN port (RJ-45 connector)
located at the lower left of the 4294A's rear panel with a vacant port of the LAN in view.
166
key.
key, and the
3rd 4th
key.
key, and the
3rd 4th
] key in the INSTRUMENT STATE block on the front panel, and press
key.
key causes the MAC address of the 4294A to appear on the
key, and similarly enter the second, the third,
key, and similarly enter the second, the third,
Chapter 12