Setting Averaging; Setting A Measurement Bandwidth - Agilent Technologies 4294A Programming Manual

Setting Averaging

Setting a measurement bandwidth

To set a measurement bandwidth, use the command given below.
• "BWFACT" on page 274
Setting averaging
Setting sweep averaging
To set or control sweep averaging, use the command given below.
• "AVER" on page 269
• "AVERFACT" on page 269
• "AVERREST" on page 269
Setting point averaging
To set point averaging, use the commands given below.
• "PAVER" on page 396
• "PAVERFACT" on page 396
Chapter 3
Setting Measurement Conditions
Setting Averaging
43