Widvtype; Wopen - Agilent Technologies 4294A Programming Manual

GPIB Command Reference

WIDVTYPE

WIDVTYPE
Syntax
WIDVTYPE {DIVS2|MULS2|DIV2|FIXed}
WIDVTYPE?
Description
For the active trace (set with the "TRAC" command on page 457), selects the method to set
a cutoff point in the trace bandwidth analysis function.
Parameters
If the measurement parameter is a vector value (for COMPLEX Z-Y), you can select
FIXed only.
Query response {DIVS2|MULS2|DIV2|FIXed}<newline><^END>
Corresponding
[Search]
key
FIXED VALUE

WOPEN

Syntax ROPEN <string>
Description
If the specified file exists, this command makes it write-enabled; otherwise, creates a new
file and makes it write-enabled. This command takes its arguments in a different way,
depending on the file format.
The size of an existing file cannot be changed. Therefore, if you want to change them,
delete the file itself using the "PURG"(406page) command and then create a new file using
this command.
This command is used in combination with the "WRITE"(463page) command and the
"CLOSE"(280page) commands, as shown in Figure 16-8 on page 412. (No query)
Parameters
Corresponding
No front panel key is available to execute this function.
key
462
DIVS2 The value obtained by dividing the measurement parameter value
at the marker position by
MULS2 The value obtained by multiplying the measurement parameter
value at the marker position and
DIV2 The value obtained by dividing the measurement parameter value
at the marker position by 2 is set as the cutoff point.
FIXed (initial Lets you set the cutoff point freely using the "WIDFVAL"
value) command on page 460.
- WIDTHS DEF MENU
}
<string> File name of up to 12 characters including its extention
Description
is set as the cutoff point.
2
2
- { MKRVAL/(√2) | MKRVAL*(√2)
Description
is set as the cutoff point.
| MKRVAL/2 |
Chapter 16