Table of Contents
Advertisement
Preparation for Using the Adjustment/Performance Test
Program
To use the E4915A/E4916A adjustment/performance test program, it is rst necessary to install
an GPIB Card. This section describes how to install it.
Installing an GPIB Card (82340 or 82341)
Install an GPIB Card in your computer (see the GPIB Card manual). The select code of the
GPIB Card should be set to \7". The GPIB Card should be the 82340 or the 82341A. Other
GPIB Cards can not be used in the Windors NT environment.
Installing HP VEE for Windows NT
Install the HP VEE for Windows NT in your computer (see the HP VEE for Windows NT
manual).
After installing HP VEE for Windows NT, run the I/O Con g utility in the HP VEE for Windows
NT group to check that the GPIB Interface Board is correctly installed.
Note
The GPIB card may not work properly if the default IRQ (Interrupt Request)
value for the GPIB card is used for other device in your PC. Changing the IRQ
value for the GPIB card may solve this problem:
1. Run the I/O Con g utility.
2. Select gpib7 GPIB0 in the Configured Interfaces box and click
NNNNNNNNNNNNNNNNNNNNNNNNNN
Edit ... .
3. Change the value in the IRQ Line: and click
4. Click
The new IRQ value should be carefully selected in order not to a ect other
devices in your PC.
Installing Adjustment/Performance Test Program into Your PC
1. Make a copy of the program le \E4915 16.EXE" in a directory of your harddisk drive.
2. Double-click the lename on the Windows' Filemanager to start extracting the
self-extracting archive.
3. You will be prompted to enter directory name for installing the program les. Click [OK] to
use default home directory ( C:\E4915_16 ).
4. Con rm that you get several new directories and les under the designated directory.
2-6 Adjustments and Performance Tests
NNNNNNNN
OK to exit the utility.
NNNNNNNN
OK .
Advertisement
Table of Contents
