Configure Iproute Add Default - Extreme Networks ExtremeWare XOS Command Reference Manual

Software version 11.5

Hide thumbs Also See for ExtremeWare XOS:

Table of Contents

ExtremeWare XOS 11.5 supports only the Summit X450 family of switches and the BlackDiamond 8800 series switch.

IP Unicast Commands

configure iproute add default

configure iproute add default <gateway> {vr <vrname>} {<metric>}

{multicast-only | unicast-only}

Adds a default gateway to the routing table.

Syntax Description

If no metric is specified, the default metric of 1 is used. If you do not specify a virtual router, the current

virtual router context is used.

Usage Guidelines

Default routes are used when the router has no other dynamic or static route to the requested

destination. A default gateway must be located on a configured IP interface. Use the

multicast-only

traffic uses the default route.

The following command configures a default route for the switch:

configure iproute add default 123.45.67.1

This command was first available in ExtremeWare XOS 10.1.

Platform Availability

This command is available on all platforms.

Specifies a VLAN gateway

Specifies a cost metric. If no metric is specified, the default of 1 is used.

Specifies the virtual router to which the route is added.

options to specify a particular traffic type. If not specified, both unicast and multicast

unicast-only

ExtremeWare XOS 11.5 Command Reference Guide

Extremeware xos 11.5