Table of Contents
Advertisement
cable telco-return spd radius-realm
cable telco-return spd radius-realm
To select a RADIUS server domain to use for the login response string, use the cable telco-return spd
radius-realm command in cable interface configuration mode. To restore the default value, use the no
form of this command.
Syntax Description
spd-number
string
Defaults
The default value is the null string.
Command Modes
Interface configuration (cable interface only)
Command History
Release
12.0(4)XI
Usage Guidelines
This command sets the RADIUS Realm parameter for the specified SPD in Telephony Channel
Descriptor (TCD) messages. When this command is configured, telco-return CMs use this realm string
to construct a domain name for the login username when responding to a PPP login query.
This command is available only in images that support telco-return. These images have a "t" as part of
Note
the image name.
Examples
The following example shows a login response string of "sandy@sunol":
router(config-if)# cable telco-return spd 3 radius-realm sunol
router(config-if)# cable telco-return spd 3 username sandy
Related Commands
Command
cable telco-return enable
cable telco-return interval
cable telco-return
registration-ip
Cisco Broadband Cable Command Reference Guide
2-272
cable telco-return spd spd-number radius-realm string
no cable telco-return spd spd-number radius-realm
Service provider descriptor (SPD) number for which this parameter is
set. Valid range is 1 through 5.
Alphanumeric string identifying a RADIUS server domain.
Modification
This command was introduced.
Description
Enables telco-return functionality.
Defines the interval for sending TCD and Termination System
Information (TSI) messages.
Selects a different IP address for the telco-return CM to send its
registration requests.
Chapter 2
Cisco CMTS Configuration Commands
OL-1581-08
Advertisement
Table of Contents
