Using System Programming - Lucent Technologies PARTNER Advanced Communications System Programming And Use Instructions

Outgoing Call Restriction Button (#114) lets you program a button on
the system phone at extension 10 to change an extension's current
Outgoing Call Restriction setting without entering System Programming
mode. For example, after a guest's departure, a hotel manager can change
the No Restriction setting of the guest room phone to Inside Only so
outside calls cannot be made from the phone after the guest checks out.

Using System Programming

System Programming changes settings for the system as a whole, or for individual
lines, pools, or extensions. You can also use System Programming to set up
dialing restrictions, define groups, or set up auxiliary equipment. Refer to the
filled-out System Planner when you are changing system settings, and be sure
that any changes in programming are recorded there.
The Programming Overlays
System Programming requires a Programming Overlay placed over the dialpad of
the system display phone at extension 10 or 11. (Overlays are provided with the
system documentation. Replacements can be ordered from the Lucent
Technologies BCS Publications Center. See
''Product Ordering Information'' on page
the Programming Overlays for the PARTNER-34D and PARTNER-18D phones.
During System Programming, the normal functions of several buttons on the
display phone at extension 10 or 11 change. For example, the left
s
becomes
Programming Overlay identifies these buttons.
You use the following special buttons while programming:
N
programming procedures. You can use these buttons to select a
procedure.
(If a procedure instructs you to press
these buttons one after the other enables you to repeat the current
programming procedure.)
n
parameters. A parameter is typically an outside line, a pool, an extension,
or a telephone list entry.
D
entries. These buttons work only for fixed data, such as a line or extension
number. They do not work for variable data such as date, time, password,
telephone numbers, or doorphone assignments.
r
Assignment (#301), removes lines from an extension; when using Pool
Extension Assignment (#314), removes pools from an extension.
i
and the right
P
and cycle forward and backward through the
p
and cycle forward and backward through a procedure's
d
and cycle forward and backward through the valid
returns the current setting to the factory setting. When using Line
''Reference Materials''
B-4.) Figure 2-3 on page 2-23
c
button becomes
N P
Programming
under
illustrates
i
button
. The
, pressing
2-21