Lucent Technologies PARTNER Advanced Communications System Programming And Use Instructions page 404

!
CAUTION:
Do not dispose of batteries in fire. Do not recharge, disassemble, install
backwards, or mix with used or other battery types—batteries may explode
or leak and cause a burn injury.
Figure 6-3. Removing or Inserting Batteries in the Battery Assembly
4. Insert two new AAA-size standard alkaline batteries into the metal spring
clips by pushing them straight in, placing the negative (–) end of one
battery into the bottom clip, and the positive (+) end of the other battery into
the top clip.
5. With the locking latch in the unlocked position (battery icon and "minus"
icon visible), slide the battery assembly into the processor module along
the battery guides on the inside of the battery compartment (see
6-4).
Tab
Figure 6-4. Inserting Battery Assembly and Batteries into Battery Compartment
6. Make sure the battery assembly is pushed in far enough that the edges of
the assembly slip behind the plastic housing of the processor module.
Pull to
remove
Push to
insert
Locking Latch
Figure
6-5
Troubleshooting