Restore Programming (#125) - Lucent Technologies PARTNER Advanced Communications System Programming And Use Instructions

Restore Programming (#125)

Description
This System Programming procedure enables you to reinstate your system and
telephone programming (except the System Day, System Date, and System
Time) to the settings saved on a PC Card at the last system backup (manual or
automatic). This procedure is useful if your system settings become corrupted, if
you make changes and decide you would rather use the former settings, or if you
replace your processor module and want to retain the system settings you had on
the previous processor module. A successful restore takes about five seconds.
NOTE:
When a restore completes successfully, the Restore Complete message
displays for two seconds at idle extensions 10 and 11, and then a System
Reset—Programming Saved (#728) occurs, disconnecting any calls in
progress . It is recommended that you warn users before beginning a
restore, or do the restore during nonbusiness hours.
Related Features
Backup Programming—Automatic (#123) automatically saves your
n
programmed settings at regular intervals.
Backup Programming—Manual (#124) is a manual procedure that you
n
can perform at any time to back up your system and telephone
programming settings.
System Reset—Programming Saved (#728) automatically occurs
n
following a successful restore. The reset disconnects any calls in progress.
Considerations
If the restore is not successful, the display shows Restore Failed or
n
Restore Failed-Try Again for two seconds. All calls that were in progress
are disconnected and all of the system and telephone programming
settings revert to the default settings.
The PC Card in the PC Card slot must be a PARTNER ACS
n
Backup/Restore PC Card, which can be purchased from Lucent
Technologies.
PC Card Slot 2 is recommended for the Backup/Restore PC Card;
n
however, either slot can be used. If the system detects Backup/Restore PC
Cards in both slots when a restore begins, the first slot is used and the
second is ignored .
5-222
Feature Reference